Venza AWD V6-3.5L (2GR-FE) (2010)
/Page-996005.png)
(b) Disconnect the connector of the center airbag sensor assembly.
Text in Illustration
Text in Illustration
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY
BRANCH WIRE)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
