Venza AWD V6-3.5L (2GR-FE) (2010)
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)
(a) Turn the ignition switch off.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK -- REPLACE YAW RATE SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Acceleration/Deceleration Sensor/Service and Repair/Removal
4WD Control ECU Communication Stop Mode
NETWORKING: CAN COMMUNICATION SYSTEM: 4WD Control ECU Communication Stop Mode
- 4WD Control ECU Communication Stop Mode
DESCRIPTION
WIRING DIAGRAM