Venza AWD V6-3.5L (2GR-FE) (2010)
41. REPLACE AIR CONDITIONING AMPLIFIER See: Heating and Air Conditioning/Control Module HVAC/Service and Repair/Removal
42. REPLACE 4WD CONTROL ECU See: Transmission Control Systems/Relays and Modules - Transmission and Drivetrain/Relays and
Modules - Transfer Case/Control Module/Service and Repair/Removal
43. REPLACE POWER MANAGEMENT CONTROL ECU See: Power and Ground Distribution/Power Distribution Module/Service and
Repair/Removal
44. REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Restraint Systems/Air Bag Systems/Impact Sensor/Service and Repair/Center
Airbag Sensor Assembly/Removal
45. REPLACE YAW RATE SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Yaw Rate Sensor/Service
and Repair/Removal
46. REPLACE STEERING ANGLE SENSOR See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Steering Angle
Sensor/Service and Repair/Removal
47. REPLACE POWER STEERING ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and Modules -
Steering/Steering Control Module/Service and Repair/Removal
48. REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK) See: Body Control Module/Service and Repair/Removal
49. REPLACE SMART KEY ECU ASSEMBLY (CERTIFICATION ECU)
50. REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (CAN NO. 1 JUNCTION CONNECTOR - ECM)
51. REPLACE ECM See: Engine Control Module/Service and Repair/Removal
52. REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (CAN NO. 2 JUNCTION CONNECTOR - COMBINATION METER)
53. REPLACE COMBINATION METER See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and
Repair/Removal and Replacement/Combination Meter/Removal
54. REPLACE CAN NO. 1 JUNCTION CONNECTOR
55. REPLACE CAN NO. 2 JUNCTION CONNECTOR
56. REPLACE ECM See: Engine Control Module/Service and Repair/Removal
Part 1
NETWORKING: CAN COMMUNICATION SYSTEM: Check CAN Bus Line for Short to +B
- Check CAN Bus Line for Short to +B
DESCRIPTION
There may be a short circuit between the CAN bus main wire and +B when no resistance exists between terminals 6 (CANH) and 16 (BAT) or 14
(CANL) and 16 (BAT) of the DLC3.