Venza AWD V6-3.5L (2GR-FE) (2010)
Standard Resistance (Check for Short):
(e) Reconnect the ECM connector.
(f) Reconnect the engine room junction block assembly connector.
(g) Reinstall the engine room junction block assembly.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (ENGINE ROOM JUNCTION BLOCK ASSEMBLY- ECM)
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK ASSEMBLY - BATTERY)
(a) Remove the engine room junction block assembly from the engine room relay block.
(b) Disconnect the cable from the negative (-) battery terminal.
(c) Disconnect the cable from the positive (+) battery terminal.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):
Standard Resistance (Check for Short):
Text in Illustration
Text in Illustration
(e) Reinstall the engine room junction block assembly.
(f) Reconnect the cable to the positive (+) battery terminal.
(g) Reconnect the cable to the negative (-) battery terminal.