Venza AWD V6-3.5L (2GR-FE) (2010)
Canister Purge Control Valve: Service and Repair
Removal
2GR-FE EMISSION CONTROL: PURGE VALVE: REMOVAL
1. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
2. REMOVE NO. 1 VACUUM SWITCHING VALVE
(a) Disconnect the No. 1 vacuum switching valve connector.
(b) Disconnect the wire harness clamp.
(c) Disconnect the 2 fuel vapor feed hoses from the No. 1 vacuum switching valve.
(d) Remove the bolt and No. 1 vacuum switching valve.