Venza AWD V6-3.5L (2GR-FE) (2010)
Variable Induction Control Valve: Testing and Inspection
Intake Air Control Valve
2GR-FE INTAKE / EXHAUST: INTAKE AIR CONTROL VALVE: ON-VEHICLE INSPECTION
1. INSPECT INTAKE AIR SURGE TANK ASSEMBLY
(a) Perform the following inspection procedure when using the Techstream:
(1) Remove the V-bank cover assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal.
(2) Stop the engine.
(3) Connect the Techstream to the DLC3.
(4) Start the engine and turn the Techstream on.
(5) Enter the following menus: Powertrain / Engine and ECT / Active Test / Active the VSV for Intake Control.
(6) Make sure that a clicking sound is heard from the intake air control valve when current flows.
If the intake air control valve does not operate, check the ACIS control circuit See: Computers and Control Systems/Testing and
Inspection/Component Tests and General Diagnostics/ACIS Control Circuit.
(7) Install the V-bank cover assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation.
(b) Perform the following inspection procedure when applying voltage between the terminals:
(1) Remove the V-bank cover assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal.
(2) Disconnect the connector from the intake air control valve.
(3) Apply battery voltage between terminals 2 (+) and 1 (-) of the intake air control valve. Check that a clicking sound is heard from the intake
air control valve.
If the operation is not as specified, replace the intake air surge tank assembly.
(4) Install the V-bank cover assembly See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation.
2. INSPECT AIR CLEANER CASE