Venza AWD V6-3.5L (2GR-FE) (2010)
(b) Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.
SST : 09224-00010
4. REMOVE FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Removal
6. REMOVE NO. 3 FRONT EXHAUST PIPE SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service
and Repair/Removal
7. REMOVE MANIFOLD STAY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and Repair/Removal
8. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and
Repair/Removal
9. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
(a) Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.
SST : 09224-00010
Installation
2GR-FE ENGINE CONTROL: AIR FUEL RATIO SENSOR: INSTALLATION
1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
(a) Using SST, install the air fuel ratio sensor to the exhaust manifold RH.