Venza AWD V6-3.5L (2GR-FE) (2010)
6. REMOVE STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Removal
7. REMOVE LOWER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Removal
8. REMOVE UPPER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Removal
9. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Removal and Replacement/Removal
10. REMOVE UNLOCK WARNING SWITCH
(a) Disconnect the connector.
(b) Insert the key into the ignition key cylinder.
(c) Disengage the 2 claws and remove the unlock warning switch from the steering column upper bracket.
Installation
DOOR LOCK: UNLOCK WARNING SWITCH: INSTALLATION
1. INSTALL UNLOCK WARNING SWITCH
(a) Engage the 2 claws and install the unlock warning switch to the steering column upper bracket.
(b) Extract the key.
(c) Connect the connector.