Venza AWD V6-3.5L (2GR-FE) (2010)
Fuel Gauge Sender: Service and Repair
Installation
2GR-FE FUEL: FUEL SENDER GAUGE ASSEMBLY: INSTALLATION
1. INSTALL FUEL SENDER GAUGE ASSEMBLY
(a) Install the fuel sender gauge assembly to the fuel tank with the 6 bolts.
Torque : 3.5 Nm (36 kgf-cm, 31 in-lbf)
NOTICE:
Be careful not to bend the arm of the fuel sender gauge assembly.
2. INSTALL REAR NO. 2 FLOOR SERVICE HOLE COVER
(a) Connect the fuel sender gauge connector.
(b) Install the rear No. 2 floor service hole cover with new butyl tape.
3. INSTALL FUEL SENDER GAUGE
(a) Install the fuel sender gauge by sliding it upward.
NOTICE:
Do not damage the wire harness.
(b) Connect the connector of the fuel sender gauge.
NOTICE:
Make sure that the fuel sender gauge arm does not bend.