Venza AWD V6-3.5L (2GR-FE) (2010)
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
(e) Check that the waterproof sheet is properly set.
(f) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
2. INSTALL CONSOLE BOX SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
4. INSTALL CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Installation
5. INSTALL NO. 2 CONSOLE BOX CARPET See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Installation
6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal and Replacement/Installation
9. INSTALL FRONT DOOR SCUFF PLATE RH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
10. INSTALL AIR CONDITIONER CONTROL ASSEMBLY See: Heating and Air Conditioning/Control Assembly/Service and Repair/Installation
11. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Removal and Replacement/Installation
12. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
13. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
14. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
and Replacement/Installation
15. INSTALL FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
17. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
18. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.