Venza AWD V6-3.5L (2GR-FE) (2010)
Seat Occupant Sensor: Testing and Inspection
SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: ON-VEHICLE INSPECTION
CAUTION:
Be sure to follow the correct removal and installation procedures of the occupant classification ECU.
1. INSPECT OCCUPANT CLASSIFICATION ECU (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Restraint Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
2. INSPECT OCCUPANT CLASSIFICATION ECU (VEHICLE INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Restraint Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
(b) Even if an airbag was not deployed, check if there is any damage to the occupant classification ECU. If there are any defects as mentioned
below, replace the occupant classification ECU with a new one:
*
Cracks, dents or chips on the case.
*
Cracks or other damage to the connector.