Venza AWD V6-3.5L (2GR-FE) (2010)
HINT
Refer to the procedure from Install Engine Assembly with Transaxle See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Removal and Replacement/Engine Assembly/Installation.
8. CONNECT TIE ROD ASSEMBLY LH
(a) Connect the tie rod assembly LH to the steering knuckle with the nut.
Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)
(b) Install a new cotter pin.
NOTICE:
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
9. CONNECT TIE ROD ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
10. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) Align the matchmarks on the steering intermediate shaft assembly and steering link assembly.
Text in Illustration
(b) Install the bolt.