Venza AWD V6-3.5L (2GR-FE) (2010)
(a) Disconnect the connector and disengage the clamp to separate the No. 3 floor wire from the rear suspension member.
16. SEPARATE REAR SUSPENSION MEMBER
(a) Support the rear suspension member with a jack using 3 wooden blocks as shown in the illustration.
Text in Illustration
HINT
Use properly sized wooden blocks to keep the jack and suspension member level.
(b) Remove the 4 nuts, 2 bolts and 2 rear lower suspension member stopper retainers.
(c) Lower the rear suspension member to the point shown in the illustration.