Venza AWD V6-3.5L (2GR-FE) (2010)
Control Module: Service and Repair
Installation
U660F AUTOMATIC TRANSMISSION / TRANSAXLE: TCM: INSTALLATION
1. INSTALL TCM
(a) Install the TCM to the transaxle.
(b) Install and tighten the 2 bolts in the order shown in the illustration.
Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
(c) Connect the connector to the TCM.
(d) Turn the lock lever and secure the connector with the lock lever.
2. INSTALL INLET NO. 1 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
3. INSTALL BATTERY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
4. INSTALL INLET NO. 2 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
5. INSTALL COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
7. INSPECT AUTOMATIC TRANSAXLE SYSTEM