Venza AWD V6-3.5L (2GR-FE) (2010)
Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)
2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
HINT
See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and Replacement/Front Drive Shaft
Assembly/Removal
3. REMOVE TRANSAXLE CASE OIL SEAL
(a) Using SST, tap out the transaxle case oil seal.
SST : 09308-00010
4. INSTALL TRANSAXLE CASE OIL SEAL
(a) Using SST and a hammer, tap in a new transaxle case oil seal.
SST : 09316-60011
SST : 09950-70010
09951-07100
Oil seal driven in depth:
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
NOTICE:
Check that the oil seal is installed in the correct direction.