Venza AWD V6-3.5L (2GR-FE) (2010)
Differential Carrier: Overhaul
Disassembly
AXLE AND DIFFERENTIAL: REAR DIFFERENTIAL CARRIER ASSEMBLY: DISASSEMBLY
1. SECURE DIFFERENTIAL CARRIER ASSEMBLY
(a) Secure the differential carrier assembly to the overhaul stand, etc.
2. REMOVE REAR DIFFERENTIAL FILLER PLUG
(a) Using a hexagon wrench (17 mm), remove the rear differential filler plug (inspection plug) and gasket.
3. REMOVE STUD BOLT
(a) Install 2 service nuts to the stud bolt.
Text in Illustration
Recommended service nut:
Thread diameter
8 mm (0.3150 in.)
Thread pitch
1.25 mm (0.0492 in.)
(b) Lock the upper nut using the lower nut.
(c) Turn the lower nut and remove the other 3 stud bolts in the same way.
HINT
If the threads of the electro magnetic control coupling sub-assembly are damaged while removing the stud bolt, replace the electro