Venza AWD V6-3.5L (2GR-FE) (2010)
Fluid - Differential: Service and Repair
AXLE AND DIFFERENTIAL: DIFFERENTIAL OIL: REPLACEMENT
1. REMOVE REAR DIFFERENTIAL CARRIER COVER PLUG
(a) Using a hexagon wrench (10 mm), remove the rear differential carrier cover plug and gasket.
2. REMOVE REAR DIFFERENTIAL DRAIN PLUG
(a) Using a hexagon wrench (10 mm), remove the rear differential drain plug and gasket, then drain the differential oil.
3. INSTALL REAR DIFFERENTIAL DRAIN PLUG
(a) Using a hexagon wrench (10 mm), install the rear differential drain plug with a new gasket.
Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)
4. ADD DIFFERENTIAL OIL
(a) Stop the vehicle in a level place.
(b) Add differential oil until the oil level is between 0 and 5 mm (0 and 0.197 in.) from the bottom lip of the rear differential carrier cover plug
opening.
Capacity: