Venza AWD V6-3.5L (2GR-FE) (2010)
4. INSTALL FRONT DRIVE SHAFT DUST COVER RH (for 2WD RH Side)
(a) Using SST and a press, install a new front drive shaft dust cover RH until the distance (A) from the tip of the center drive shaft to the front
drive shaft dust cover RH meets the specification.
SST : 09527-10011
Distance (A)
NOTICE:
*
The dust cover should be completely installed.
*
Be careful not to damage the dust cover.
5. INSTALL FRONT DRIVE SHAFT DUST COVER LH (for LH Side)
(a) Using SST and a press, install a new front drive shaft dust cover LH.
SST : 09527-10011
NOTICE:
*
The dust cover should be completely installed.
*
Be careful not to damage the dust cover.
6. INSTALL FRONT AXLE OUTBOARD JOINT BOOT
(a) Wrap the spline of the drive shaft with vinyl tape to prevent the boot from being damaged.
Text in Illustration
(b) Install new parts to the front drive outboard joint shaft assembly in the following order:
(1) No. 2 front axle outboard joint boot clamp