Venza AWD V6-3.5L (2GR-FE) (2010)
NOTICE:
Do not damage the oil seal contact surface on the case.
4. INSTALL TRANSFER CASE FRONT OIL SEAL
(a) Using SST, drive in a new transfer case front oil seal into the transfer case until it reaches the position shown in the illustration.
SST : 09950-60010
09951-00350
09951-00580
09952-06010
SST : 09950-70010
09951-07150
Drive in depth:
33.5 to 34.5 mm (1.319 to 1.358 in.)
NOTICE:
Do not tilt the oil seal during installation.
(b) Apply a small amount of MP grease to the lip of the oil seal.
5. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and Replacement/Front Drive Shaft
Assembly/Installation.
6. ADD TRANSFER OIL
7. INSPECT TRANSFER OIL See: Fluid - Transfer Case/Testing and Inspection