Venza AWD V6-3.5L (2GR-FE) (2010)
5. INSTALL TRANSFER CASE REAR OIL SEAL
(a) Using SST and a hammer, drive in a new transfer case rear oil seal into the transfer extension housing sub-assembly until it reaches the
position shown in the illustration.
SST : 09325-20010
Drive in depth:
1.1 to 1.9 mm (0.0433 to 0.0748 in.)
NOTICE:
Do not tilt the oil seal during installation.
(b) Apply a small amount of MP grease to the lip of the oil seal.
6. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement/Installation
7. FULLY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement/Installation
8. INSTALL CENTER EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
9. INSTALL TAIL EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Installation
10. INSPECT TRANSFER OIL See: Fluid - Transfer Case/Testing and Inspection
11. INSPECT EXHAUST GAS LEAK