Venza FWD L4-2.7L (1AR-FE) (2009)
weatherstrip.
E. Disengage the 2 claws and disconnect the front door inside handle sub-assembly.
7. Reassembly is reverse order of disassembly procedure.
Rear Door
1. Disconnect the cable from the negative battery terminal.
2. Using a molding remover disengage the 3 claws and remove the rear door inside handle bezel plug.
3. Remove the rear power window regulator switch assembly with rear door armrest base panel.
A. Using a molding remover disengage the 2 clips and 5 claws.
B. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.
4. Remove the rear door trim board sub-assembly.
A. Remove the 2 screws.