Venza FWD L4-2.7L (1AR-FE) (2009)
Yaw Rate Sensor: Service and Repair
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL YAW RATE AND ACCELERATION SENSOR
(a) Install the yaw rate and acceleration sensor to the bracket with the 2 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44in-lbf)
(b) Install the yaw rate and acceleration sensor with bracket with the 2 bolts.
Torque: 13 Nm (127 kgf-cm, 9ft-lbf)
NOTICE:
-
Be sure to insert the yaw rate and acceleration sensor claw into the stopper hole while installing the yaw rate and acceleration sensor.
-
Do not damage the yaw rate and acceleration sensor.
-
Make sure that the yaw rate and acceleration sensor is installed securely.
(c) Connect the connector to the yaw rate and acceleration sensor.
NOTICE: Make sure that the yaw rate and acceleration sensor connector is connected securely.
2. INSTALL NO. 4 CENTER MEMBER FLOOR REINFORCE SUB-ASSEMBLY
(a) Install the No. 4 center member floor reinforce sub-assembly with the 7 bolts.
Torque: 19 Nm (194 kgf-cm, 14ft-lbf)
(b) Return the floor carpet assembly to an original state.
3. INSTALL CONSOLE BOX SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
4. INSTALL POSITION INDICATOR HOUSING ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation