Venza FWD L4-2.7L (1AR-FE) (2009)
(d) Check that the oil is drained from the oil filter. Then disconnect the pipe as shown in the illustration and remove the O-ring.
(e) Using SST, remove the oil filter cap.
SST: 09228-06501
NOTICE: Do not remove the oil filter bracket clip.
(f) Remove the oil filter element and O-ring from the oil filter cap.
NOTICE: Be sure to remove the cap O-ring by hand, without using any tools, to prevent damage to the cap O-ring groove.
3. INSTALL OIL FILTER CAP ASSEMBLY
(a) Clean the inside of the oil filter cap, its threads and its O-ring groove.
(b) Apply a small amount of engine oil to a new O-ring and install it to the oil filter cap.
(c) Set a new oil filter element into the oil filter cap.
(d) Remove any dirt or foreign matter from the installation surface of the engine.
(e) Apply a small amount of engine oil to the O-ring again and temporarily install the oil filter cap.
NOTICE: Make sure that the O-ring does not get caught between the parts.