Venza FWD L4-2.7L (1AR-FE) (2009)
(b) Loosen the 2 lock nuts.
(c) If the length difference between the left and right rear No. 2 suspension arm assemblies is not within the specified range, adjust it by following
the procedures below.
(1) If the toe-in measurement is greater than the specified range, extend the shorter rear No. 2 suspension arm assembly by rotating the
adjusting tube in the direction of arrow B in the illustration.
(2) If the toe-in measurement is less than the specified range, shorten the longer rear No. 2 suspension arm assembly by rotating the adjusting
tube in the direction of arrow A in the illustration.
(3) Measure the toe-in.
(d) Turn the right and left adjusting tubes by an equal amount to adjust toe-in.
HINT:
-
Try to adjust the toe-in to the center of the specified range.
-
One turn of each adjusting tube will adjust the toe-in by approximately 11.1 mm (0.437 in.).
(e) Tighten the 2 lock nuts.
Torque: 56 Nm (570 kgf-cm, 41ft-lbf)
6. ADJUST TOE-IN (for AWD)
(a) Measure the distance between each wheel disc and the center of the toe-adjusting cam.
Difference in the distance between each wheel disc and the center of the toe-adjusting cam:
1.0 mm (0.0393 in.) or less
If the left-right difference is larger than 1.0 mm (0.0393 in.), adjust it by following the procedures below.
(b) Loosen the toe-adjust cam set nuts.
(c) If the distance between each wheel disc and the center of the toe-adjusting cam is not within the specified range, adjust it by following the
procedures below.
(1) If the toe-in measurement is greater than the specified range, extend the shorter rear No. 2 suspension arm assembly by rotating the adjust
cams in the direction of arrow B in the illustration.
(2) If the toe-in measurement is less than the specified range, shorten the longer rear No. 2 suspension arm assembly by rotating the adjust
cams in the direction of arrow A in the illustration.
(3) Measure the toe-in.
(d) Turn the adjust cams by an equal amount to adjust toe-in.
HINT:
-
Try to adjust the toe-in to the center of the specified range.
-
One graduation of each adjusting cam will adjust the toe-in by approximately 3.3 mm (0.130 in.).
(e) Tighten the toe-adjust cam set nuts.
Torque: 100 Nm (1020 kgf-cm, 74ft-lbf)