Venza FWD L4-2.7L (1AR-FE) (2009)
/Page-1196001.png)
Camshaft Position Sensor: Service and Repair
Installation
1AR-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)
(a) Apply a light coat of engine oil to the O-ring of the sensor.
NOTICE: Make sure that the O-ring is not cracked or does not jump out of position during installation.
(b) Apply adhesive to 2 or 3 threads of the bolt.
Text in Illustration
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.
(c) Install the sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7ft-lbf)
(d) Connect the sensor connector.
2. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)
(a) Apply a light coat of engine oil to the O-ring of the sensor.
NOTICE: Make sure that the O-ring is not cracked or does not jump out of position during installation.
(b) Apply adhesive to 2 or 3 threads of the bolt.
Text in Illustration
Adhesive:
