Venza FWD L4-2.7L (1AR-FE) (2009)
Braking Sensor/Switch: Testing and Inspection
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: BRAKE PEDAL LOAD SENSING SWITCH: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH
NOTICE:
-
Do not remove the brake pedal load sensing switch from the brake pedal support assembly.
-
When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.
(a) Disconnect the brake pedal load sensing switch connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the value is not as specified, replace the brake pedal support assembly See: Brakes and Traction Control/Brake Pedal Assy/Service and
Repair/Removal and Replacement/Removal.