Venza FWD L4-2.7L (1AR-FE) (2009)
Wheel Speed Sensor: Service and Repair
Rear Speed Sensor
Components
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for 2WD): COMPONENTS
COMPONENTS
ILLUSTRATION
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR (for 2WD): REMOVAL
REMOVAL
HINT:
-
Use the same procedure for the RH side and LH side.
-
The following procedure is for the LH side.
-
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and
bearing assembly.
-
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Repair Instruction - Initialization.
2. REMOVE REAR WHEEL
3. SEPARATE REAR SPEED SENSOR WIRE