Venza FWD L4-2.7L (1AR-FE) (2009)
/Page-1299004.png)
(k) Install the shift lever assembly with the 4 nuts.
Torque: 12 Nm (122 kgf-cm, 9ft-lbf)
(l) Connect the 2 connectors.
(m)Push the lock piece into the adjuster case.
Test in Illustration
NOTICE: Securely press in the lock piece until it locks.
(n) After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.
(o) Install the console box sub-assembly See: Shifter A/T/Service and Repair/Removal and Replacement/Installation.
