Venza FWD L4-2.7L (1AR-FE) (2009)
^
When installing the transmission valve body assembly, be careful NOT to allow the speed sensor and transaxle case to interfere with each other.
^
Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.
^
First, temporarily tighten the bolts marked by (*1) in the illustration because they are positioning bolts.
7. Install the valve body oil strainer assembly.
A. Coat a new 0-ring with ATF and install it to the oil strainer.
Ensure that the 0-ring is not twisted or pinched.
B. Install the oil strainer to the valve body with the 2 bolts.
Torque: 9.6 N*m (98 kgf*cm, 85 in*lbf)
8. Install the automatic transaxle oil pan sub-assembly.