Venza FWD L4-2.7L (1AR-FE) (2009)
(a) Apply positive (+) battery voltage to connector terminal 2 (B).
NOTICE: Do not apply positive (+) battery voltage to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the
motor.
(b) Connect a ground lead to connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).
(c) Check that the motor gear rotates smoothly as follows:
OK:
Text in Illustration
-
If the result is not as specified, replace the rear power window regulator motor assembly RH.
CAUTION: Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor
and regulator assembly onto the door.