Venza FWD L4-2.7L (1AR-FE) (2009)
HINT: Use the same procedure for the RH side and LH side See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release
Cable/Service and Repair/Removal.
3. REMOVE FRONT FENDER LINER RH See: Washer Motor (for Front Side)/Removal
4. DRAIN WINDSHIELD WASHER FLUID
(a) Disconnect the washer hose from the rear washer motor and pump assembly, and drain the washer fluid.
HINT: Use a container to collect the washer fluid.
5. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY
(a) Disconnect the connector.
(b) Remove the rear washer motor and pump assembly.
HINT: Use a container to collect the washer fluid.
Installation
WIPER / WASHER: WASHER MOTOR (for Rear Side): INSTALLATION
INSTALLATION
1. INSTALL REAR WASHER MOTOR AND PUMP ASSEMBLY