Venza FWD V6-3.5L (2GR-FE) (2010)
2. INSTALL REAR DOOR OUTSIDE MOULDING See: Spoilers, Flaps, and Air Dams/Mud Flap/Service and Repair/Installation
3. INSTALL REAR DOOR LOWER OUTSIDE STRIPE
4. INSTALL NO. 2 BLACK OUT TAPE
5. INSTALL REAR DOOR OUTSIDE STRIPE
6. INSTALL REAR DOOR UPPER WINDOW FRAME MOULDING
7. INSTALL REAR DOOR REAR WINDOW FRAME MOULDING
8. INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING
9. INSTALL REAR DOOR BELT MOULDING
10. INSTALL REAR DOOR PANEL PROTECTOR
(a) Engage the 6 clips and install the rear door panel protector.
11. INSTALL REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY
(a) Apply MP grease to the sliding parts of the rear door outside handle frame sub-assembly.
(b) Engage the door handle nut and claw.
(c) Using a T30 "TORX" socket wrench, install the rear door outside handle frame sub-assembly with the screw.
Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)