Venza FWD V6-3.5L (2GR-FE) (2010)
4. REMOVE DECK SIDE TRIM BOX LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and Replacement/Removal
5. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
6. REMOVE DECK SIDE TRIM BOX RH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and Replacement/Removal
7. REMOVE NO. 1 DECK BOARD See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and Replacement/Removal
8. REMOVE REAR SEAT SUB FLOOR PANEL ASSEMBLY See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
9. REMOVE ELECTRICAL KEY OSCILLATOR
(a) Disconnect the connector.
(b) Disengage the clamp and remove the electrical key oscillator.
NOTICE:
Be careful when removing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.
Installation
THEFT DETERRENT / KEYLESS ENTRY: ELECTRICAL KEY OSCILLATOR (for Rear Floor): INSTALLATION
1. INSTALL ELECTRICAL KEY OSCILLATOR
(a) Engage the clamp and install the electrical key oscillator.
NOTICE:
Be careful when installing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.
(b) Connect the connector.
2. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
3. INSTALL NO. 1 DECK BOARD See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and Replacement/Installation
4. INSTALL DECK SIDE TRIM BOX RH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and Replacement/Installation
5. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
6. INSTALL DECK SIDE TRIM BOX LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and Replacement/Installation