Venza FWD V6-3.5L (2GR-FE) (2010)
Seat)/Disassembly
12. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
(a) Remove the 18 hog rings and the separate type front seat cushion cover.
(b) Cut off the 25 tack pins that fasten the seat heater, and then remove the separate type front seat cushion heater assembly from the separate type
front seat cushion cover.
Installation
SEAT: FRONT SEAT CUSHION HEATER: INSTALLATION
1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
(a) Using a tacker, install the separate type front seat cushion heater to the end of the separate type front seat cushion cover with 25 new tack pins.
NOTICE:
Be careful not to damage the cushion.
(b) Using hog ring pliers, temporarily install the separate type front seat cover with 18 new hog rings.