Venza FWD V6-3.5L (2GR-FE) (2010)
Vacuum Brake Booster: Service and Repair
Installation
BRAKE SYSTEM (OTHER): BRAKE BOOSTER: INSTALLATION
1. INSTALL CHECK VALVE GROMMET
(a) Install a new check valve grommet to the brake booster assembly.
2. INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY
(a) Install the brake vacuum check valve assembly to the brake booster assembly.
3. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
(a) Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.
(b) Set the push rod length as shown in the illustration.
Text in Illustration
Standard length*1:
155.1 to 156.1 mm (6.11 to 6.15 in.)
(c) Tighten the lock nut.
Torque : 26 Nm (265 kgf-cm, 19 ft-lbf)
4. INSTALL BRAKE BOOSTER GASKET
(a) Install a new brake booster gasket to the brake booster assembly.
5. INSTALL BRAKE BOOSTER ASSEMBLY
(a) Install the brake booster assembly to the body with the 4 nuts.