Venza FWD V6-3.5L (2GR-FE) (2010)
23. SEPARATE COOLER CONDENSER ASSEMBLY
(a) Remove the 4 bolts and separate the cooler condenser assembly.
24. REMOVE RADIATOR ASSEMBLY
(a) Disconnect the 3 wire harness clamps and connector.
(b) Remove the radiator assembly and fan assembly with motor.
NOTICE:
Do not apply any excessive force to the cooler condenser assembly or pipe when removing the radiator assembly.
(c) Remove the 2 radiator support cushions and 2 lower radiator supports.
(d) Release the 3 snap fits and pull up the fan assembly with motor from the radiator assembly with the 2 guides to remove the fan assembly with
motor.