Venza FWD V6-3.5L (2GR-FE) (2010)
(c) Uniformly loosen and remove the 13 bearing cap bolts in several steps and in the sequence shown in the illustration.
NOTICE:
Uniformly loosen the bolts while keeping the camshaft level.
(d) Remove the 5 camshaft bearing caps.
51. REMOVE NO. 3 CAMSHAFT
(a) Remove the No. 3 camshaft.
52. REMOVE NO. 4 CAMSHAFT
(a) Remove the No. 4 camshaft.
53. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY LH
(a) Remove the camshaft housing sub-assembly LH by prying between the cylinder head and camshaft housing sub-assembly LH with a
screwdriver.
Text in Illustration
NOTICE:
Be careful not to damage the contact surfaces of the cylinder head and camshaft housing sub-assembly LH.
HINT
Tape the screwdriver tip before use.