Venza FWD V6-3.5L (2GR-FE) (2010)
(2) Tighten the cylinder head bolts another 90°.
(e) Step 3
(1) Tighten the cylinder head bolts an additional 90°.
(2) Check that the painted mark is now facing rearward.
(f) Tighten the 2 bolts in the order shown in the illustration.
Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)
5. INSTALL WATER OUTLET See: Service and Repair/Overhaul/Reassembly
6. INSTALL VALVE STEM CAP
(a) Install the 24 valve stem caps.
7. INSTALL VALVE LASH ADJUSTER ASSEMBLY
NOTICE:
*
Keep the lash adjuster free of dirt and foreign objects.
*
Only use clean engine oil.
(a) Place the lash adjuster into a container filled with engine oil.
(b) Insert the tip of SST into the lash adjuster plunger and use the tip to press down on the check ball inside the plunger.