Venza FWD V6-3.5L (2GR-FE) (2010)
Water Pump: Service and Repair
Installation
2GR-FE COOLING: WATER PUMP: INSTALLATION
1. INSTALL WATER PUMP ASSEMBLY
(a) Install a new water pump gasket and the water pump assembly with the 16 bolts.
Bolt A - Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
Bolts B and C - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
NOTICE:
*
Make sure that there is no oil on the threads of bolts A.
*
Be sure to replace 2 bolts C with new ones or reuse them after applying adhesive 1344.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
2. INSTALL WATER PUMP PULLEY
(a) Temporarily install the water pump pulley with the 4 bolts.
(b) Using SST, hold the water pump pulley.
SST : 09960-10010
09962-01000
09963-00700
(c) Tighten the 4 bolts.
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
3. INSTALL WATER INLET HOUSING See: Service and Repair/Overhaul/Reassembly
4. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Unit/Installation
5. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Unit/Installation
6. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH See: Service and Repair/Overhaul/Reassembly