Venza FWD V6-3.5L (2GR-FE) (2010)
(d) Remove the 3 gaskets from the front No. 3 exhaust pipe sub-assembly.
9. REMOVE MANIFOLD STAY
(a) Remove the bolt, nut and manifold stay.
10. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
(a) Disconnect the air fuel ratio sensor connector (for Bank 1 Sensor 1).
(b) Using a 12 mm deep socket wrench, remove the 6 nuts and exhaust manifold sub-assembly RH.
11. REMOVE EXHAUST MANIFOLD TO HEAD GASKET
(a) Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.
12. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) See: Powertrain Management/Computers and Control Systems/Oxygen
Sensor/Service and Repair/Air Fuel Ratio Sensor/Removal
13. REMOVE FRONT EXHAUST PIPE ASSEMBLY See: Exhaust Pipe/Service and Repair/Removal
14. REMOVE NO. 2 MANIFOLD STAY
(a) Remove the bolt, nut and No. 2 manifold stay.
15. REMOVE NO. 2 OIL LEVEL DIPSTICK GUIDE