Venza FWD V6-3.5L (2GR-FE) (2010)
Exhaust Pipe: Service and Repair
Installation
2GR-FE INTAKE / EXHAUST: EXHAUST PIPE: INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR
(a) Install the heated oxygen sensor See: Powertrain Management/Computers and Control Systems/Oxygen Sensor/Service and Repair/Heated
Oxygen Sensor/Installation.
2. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(a) Install a new gasket to the front exhaust pipe assembly.
(b) Install the front exhaust pipe assembly with the 2 nuts.
Torque : 55 Nm (561 kgf-cm, 40 ft-lbf)
(c) Connect the heated oxygen sensor connector (for Bank 2 Sensor 2).
(d) Install the No. 1 exhaust pipe support bracket with the 2 nuts.
Torque : 33 Nm (336 kgf-cm, 24 ft-lbf)
3. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY
(a) Install 2 new gaskets to the front No. 3 exhaust pipe sub-assembly.
(b) Install the front No. 3 exhaust pipe sub-assembly with the 2 bolts and 2 nuts.