Venza FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
NOTICE:
Take care not to damage the seal cover of the bearing when installing the snap ring.
(f) Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing up.
Text in Illustration
NOTICE:
*
Do not expand the snap ring by more than 35.5 mm (1.39 in.) when installing it.
*
Do not damage the seal cover of the bearing when installing the snap ring.
(g) Install the magnetic clutch washers and magnetic clutch hub.
NOTICE:
Do not change the combination of the magnetic clutch washers used before disassembly.
(h) Using SST, hold the magnetic clutch hub and install the bolt.
SST : 09985-00270
Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)
NOTICE:
Make sure that there is no foreign matter or oil on the compressor shaft, bolt and clutch hub.
2. INSPECT MAGNETIC CLUTCH CLEARANCE
(a) Set the dial indicator to the magnetic clutch hub.