Venza FWD V6-3.5L (2GR-FE) (2010)
Control Assembly: Service and Repair
Removal
HEATING / AIR CONDITIONING: AIR CONDITIONING PANEL: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Removal and Replacement/Removal
3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Removal
4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
(a) Remove the screw.
(b) Apply protective tape to the area shown in the illustration.
Text in Illustration
(c) Using a moulding remover, disengage the 2 clips and 4 guides as shown in the illustration.
(d) Disconnect the connector and remove the air conditioning control assembly.