Venza FWD V6-3.5L (2GR-FE) (2010)
Headlamp Bulb: Service and Repair
Removal
LIGHTING (EXT): HIGH INTENSITY DISCHARGE HEADLIGHT BULB: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system See: Restraint
Systems/Air Bag Systems/Service Precautions.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE NO. 1 HEADLIGHT BACK COVER
(a) Release the set spring as shown in the illustration.
(b) Disengage the 2 guides and remove the No. 1 headlight back cover.
3. REMOVE HEADLIGHT GASKET
(a) Remove the headlight gasket.
NOTICE:
Do not reuse the removed headlight gasket. Be sure to install a new headlight gasket to prevent water ingress.
4. REMOVE DISCHARGE HEADLIGHT BULB
(a) Turn the light control ECU socket in the direction indicated by the arrow shown in the illustration and disconnect it.