Venza FWD V6-3.5L (2GR-FE) (2010)
/Page-1061001.png)
Crankshaft Position Sensor: Service and Repair
Removal
2GR-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: REMOVAL
1. REMOVE COMPRESSOR AND MAGNETIC CLUTCH
(a) Remove the compressor and magnetic clutch See: Heating and Air Conditioning/Compressor HVAC/Service and Repair/Removal and
Replacement/Removal.
2. REMOVE CRANK POSITION SENSOR
(a) Disconnect the crank position sensor connector.
(b) Remove the bolt and crank position sensor.
