Venza FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
(d) Reconnect the ECM connector.
NG -- INSPECT IG2 RELAY
OK -- Continue to next step.
3. INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY (EFI MAIN RELAY)
(a) Remove the engine room junction block assembly from the engine room relay block.
(b) Disconnect the engine room junction block assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
Text in Illustration
(d) Reconnect the engine room junction block assembly connector.
(e) Reinstall the engine room junction block assembly.
NG -- REPLACE ENGINE ROOM JUNCTION BLOCK ASSEMBLY See: Lighting and Horns/Daytime Running Lamp/Daytime
Running Lamp Relay/Service and Repair/Removal
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK ASSEMBLY - ECM)
(a) Remove the engine room junction block assembly from the engine room relay block.
(b) Disconnect the engine room junction block assembly connector.
(c) Disconnect the ECM connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):