toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Fuel Pressure Release|Service and Repair|Page 2809 > < Fuel Pressure|Specifications|Page 2804
Page 1
background image

Fuel Pressure Release: Service and Repair

2GR-FE FUEL: FUEL SYSTEM: PRECAUTION

1. BEFORE WORKING ON FUEL SYSTEM

(a) When disconnecting a fuel line, fuel will splash. So observe the following precautions:

(1) Do not smoke or work near fire when handling the fuel system.

(2) Keep gasoline away from rubber or leather parts.

(3) Perform the Discharge Fuel System Pressure procedure below before disconnecting a fuel line to prevent gasoline from spilling out.

2. DISCHARGE FUEL SYSTEM PRESSURE

CAUTION:
*

The Discharge Fuel System Pressure procedure must be performed before disconnecting any part of the fuel system.

*

After performing the Discharge Fuel System Pressure procedure, pressure will remain in the fuel lines. When disconnecting a fuel
line, cover it with a shop rag or a piece of cloth to prevent fuel from spraying or coming out.

(a) Remove the rear seat assembly (for LH side)    See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly

(for LH Side)/Removal.

(b) Remove the rear seat assembly (for RH side)    See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly

(for RH Side)/Removal.

(c) Turn over the rear floor carpet and the rear floor silencer.

(d) Remove the service hole cover and disconnect the fuel pump connector.

(e) Start the engine.

(f) After the engine has stopped, turn the ignition switch off.

HINT
DTC P0171/25 (fuel problem) may be detected.

(g) Crank the engine again. Check that the engine does not start.

(h) Remove the fuel tank cap to discharge pressure from the fuel tank.

(i) Disconnect the cable from the negative (-) battery terminal.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected  
  See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.

(j) Reconnect the fuel pump connector.

(k) Install the rear floor service hole cover.

(l) Install the rear floor carpet and the rear floor silencer.

(m)Install the rear seat assembly (for LH side)    See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly

(for LH Side)/Installation.

Fuel Pressure Release|Service and Repair|Page 2809 > < Fuel Pressure|Specifications|Page 2804