Venza FWD V6-3.5L (2GR-FE) (2010)
Child Seat Tether Attachment: Service and Repair
Installation
SEAT BELT: CHILD RESTRAINT SEAT TETHER ANCHOR: INSTALLATION
1. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
(a) Engage the guide.
(b) Install the child restraint seat tether anchor bracket with the bolt.
Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)
HINT
Use the same procedure for the other 2 child restraint seat tether anchor brackets.
2. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Installation
3. INSTALL NO. 1 DECK BOARD See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
4. INSTALL DECK SIDE TRIM BOX RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
5. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
6. INSTALL DECK SIDE TRIM BOX LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
7. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
8. INSTALL DECK BOARD ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation