Venza FWD V6-3.5L (2GR-FE) (2010)
(e) Remove the bolt and front airbag sensor from the body.
NOTICE:
Loosen the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT AIRBAG SENSOR: INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Insert the pin (stopper) into the body hole.