Venza FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
HINT
When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting,
as it may result in an insecure fit.
(e) Check that there is no looseness in the installation parts of the door side airbag sensor.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Reassembly
3. INSTALL COURTESY LIGHT ASSEMBLY See: Lighting and Horns/Courtesy Lamp/Service and Repair/Installation
4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver
Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and Repair/Reassembly
5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger
Side) See: Sensors and Switches/Sensors and Switches - Windows and Glass/Power Window Switch/Service and Repair/Front Passenger Side
Power Window Switch/Installation
6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Reassembly
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
8. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear.
9. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.